AIR TOOL SAFETY

You should read, understand and follow all of the safety information contained in these guidelines prior to using any air tool. We recommend that you keep these instructions for your future reference.

Pneumatic tools are designed to be used with sanding belts, sanding discs, cut off wheels, carbide burs and other tools or abrasive products. They should only be used for the specific application the tool was designed for, and within the tool’s capacity and ratings.

Use of any air tool in any other manner, or with any other accessories than the tool was designed for, could lead to unsafe operating conditions, a safety code violation, and someone getting hurt.

Do not use any cutting tool or abrasive product that has a maximum safe RPM that is less than the RPM rating of the air tool. Never spin a product faster than the specified safe RPM.

Never exceed the maximum input air pressure for your air tool. Always check the instructions for each device. Too much air pressure may cause an air tool to move too fast.

If you notice any abnormal noise or vibration when operating or using any air tool, immediately discontinue its use and inspect for worn or damaged components (mounting hardware, abrasive product, sanding belt, buffing wheel, bur, etc). Correct or replace the suspect component. If abnormal noise or vibration still exists, repair or replace the air tool.

Never operate air tools without all the guards or safety features in place and in proper working order. Do not remove or disable any safety feature.

Make sure the air tool is disconnected from its air source before servicing, inspecting, maintaining or cleaning, and before changing any tool, accessory or abrasive product.

Prior to use, inspect the abrasive product, disc pad, sanding belt, buffing wheels, cut off wheel, grinding wheel, bur or any other accessory for possible damage. If damaged, remove and replace with a new abrasive product or accessory.

Never grab a spinning part. Wait until the tool comes to a complete stop before setting the air tool down or attempting to change a tool.

Properly maintain your air compressor, air lines, filters and regulators. Only those who are properly trained should use or service air tools and equipment.

Work when you are alert, in well-lit and well-ventilated areas, and wearing proper protective attire.

Do not operate air tools if you are sneezy, sleepy, dopey, or grumpy, or while under the influence of alcohol or any drugs (legal or otherwise).

Air tool operators and other personnel must always wear protection for eyes, ears, and respiratory protection when in the work area or while operating pneumatic air tools. We also suggest long sleeves when using air sanders, belts and discs may snag a part and fly off. Protect your arms.

Follow your employer’s safety policy for PPE’s and / or ANSI Z87.1 or any other current local / national standard for eyewear and other personal protective equipment requirements.