MANDRELS

Point mandrel with 1/8” shank with 3-48 thread and nut. Fits 1/16” hole in Cratex points 4, 6, 8 & 10.

Designed for use with small rubberized abrasive points, cones, cylinders and bullets.

Best results with Cratex Rubberized abrasives are usually obtained at 30% to 80% of the maximum safe operating speeds and a light work pressure.

Mandrels and mounted accessories used improperly are dangerous. Comply with American National Standards Institute Safety Code B7.1 and Occupational Safety and Health Act covering: speed, safety guards, flanges, mounting procedures, general operating rules, handling, storage and inspection. Always wear safety glasses when using these products.

NOTE: MAXIMUM SAFE SPEED DETERMINED WITH 1/2" OR LESS EXPOSED MANDREL LENGTH. FOR EACH ADDITIONAL 1/4" OF OVERHANG DECREASE THE SPEED BY AT LEAST 20%.

ALWAYS WEAR SAFETY GLASSES WHEN USING POINT MANDRELS

Pack of 12 point mandrels