PEGAS

Allows top feeding of your scroll saw blades!

The Pegas SCP-C100 scroll saw blade clamp fits the following scroll saws:

Axminster Trade Series EX-16, EX-21, EX-30 scroll saws

Carbatec CTEX-16CEC/SS400C, CTEX-21CEC/SS530C, CTEX-30CEC/SS560C

Delta 40-690 and 40-694

Excalibur EX16, EX21, EX30, black, green & anniversary scroll saw

Jet JWSS-22

King Excelsior 16”/ 21”/ 30” scroll saw
NOTE: Will not fit the Chinese King

Pegas SCP16, SCP21, SCP 30 scroll saw

Seyco ST-21 scroll saw

It will also fit the upper & lower chucks on the Jet scroll saw

FEATURES:

Allows for top-feeding of the scroll saw blades for faster and easier blade changes

40% lighter than the OEM head, reducing the stress on the bearings

Made of solid 7075 aircraft grade aluminum. Won't bend during tension adjustment like the cast OEM heads do, making proper tension adjustment difficult.

Increases life of the scroll saws

You will need the following tools for assembly: a 3mm hex key, a 7mm open-end wrench, and a 10mm open-end wrench. These tools are not included in the kit.

Everything else you need to repair or upgrade your scroll saw is included: 4 bearings, 2 thumb screws, 2 set screws, and two hex nuts.

To remove the old head remove the two set screws and hex nuts. The head has two bearings in the arms. Carefully slide the head off. Remove the old bearings, and replace with the new bearings that come with the kit. Replace the new Pegas head, and insert the screws. Be careful not to over-tighten the screws and nuts…a snug-fit is plenty good.

Installation Video: www.scies.ch/blade-chuck-heads

Happy scrolling!