Allows top feeding of your scroll saw blades!
The Pegas SCP-C100 scroll saw blade chuck head fits the following scroll saws:
Axminster Trade Series EX-16, EX-21, EX-30 scroll saws
Carbatec CTEX-16CEC/SS400C, CTEX-21CEC/SS530C, CTEX-30CEC/SS560C
DeWalt DW788 20" (Use the DeWalt lower tension lever for rough adjustment, and the Pegas upper lever to fine-tune things)
Excalibur EX16, EX21, EX30, black, green & anniversary scroll saw
Excelsior 16/ 21/ 30 scroll saw
King scroll saw
Pegas SCP16, SCP21, SCP 30 scroll saw
Seyco ST-21 scroll saw
It will also fit the upper & lower chucks on the Jet scroll saw
Allows for top-feeding of the scroll saw blades for faster and easier blade changes
40% lighter than the OEM head, reducing the stress on the bearings
Made of solid 7075 aircraft grade aluminum. Won't bend during tension adjustment like the cast OEM heads do, making proper tension adjustment difficult.
Increases life of the scroll saws
You will need the following tools for assembly: a 3mm hex key, a 7mm open-end wrench, and a 10mm open-end wrench. These tools are not included in the kit.
Everything else you need to repair or upgrade your scroll saw is included: 4 bearings, 2 thumb screws, 2 set screws, and two hex nuts.
To remove the old head remove the two set screws and hex nuts. The head has two bearings in the arms. Carefully slide the head off. Remove the old bearings, and replace with the new bearings that come with the kit. Replace the new Pegas head, and insert the screws. Be careful not to over-tighten the screws and nuts
a snug-fit is plenty good.